CEWELD Magnesium 92/8 Tig
Is an equivalent for RE-ON LAS 423

RE-ON LAS 423

Ceweld product

Type

Magnesium welding wire for Tig welding

classification

AWS

A 5.19: ER AZ92A

EN ISO

17672: Mg001

Applications

Magnesium casting repairs, broken or wornout parts of different Magnesium alloys.

Type

Magnesium welding wire for Tig welding

Applications

Magnesium casting repairs, broken or wornout parts of different Magnesium alloys.

Properties

Melting Point 1112°F, Magnesium 92/8 is Mg - 9 Al - 2 Zn welding alloy which finds wide use for fabricating and repair welding of many similar compositions. Casting repair and refurbishment is the most common application.Magnesium 92/8 is preferred for joining many casting alloys.

Classification

AWS

A 5.19: ER AZ92A

EN ISO

17672: Mg001

Suitable for

Magnesium alloys, 2L124, 2L125, L122. AMS 4484, 4434, 4453, AZ31B, AZ10A, ZK21A, AM100A, AZ61A, AZ63A, AZ80A, AZ81A, AZ91A, AZ92A, AMS 4360, AZ casting alloys to: EK41A, EZ33A, HK31A, HM21A, HM31A, HZ32A, K1A (except AZ61A)

Welding positions

Redrying

Not required

Gas acc. EN ISO 14175

I1

Analysis

Si	Mn	P	Ni	Fe	Cu	Zn	Sn	Al	Mg	Ag	Cd
0.04	0.15			0.004		2		8.3	Rem.

Mechanical Properties

Heat Treatment	R_P0,2 (MPa)	Rm (MPa)	A5 (%)	Hardness
Heat Treatment	R_P0,2 (MPa)	Rm (MPa)	A5 (%)	Hardness
As Welded	95	170	2	65 HB

Product sheet

product sheet

declaration of performance

declaration of conformity

product sheet

Ask quotation

Certilas

Certilas

Disclaimer

Whilst all reasonable efforts have been made to ensure the accuracy of the information contained, the information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and any liability incurred from any reliance thereon is expressively disclaimed. Typical data are those obtained when welded and tested in accordance to prescribed standards, and should not be assumed to be the expected results in a particular application or weldment. Other tests and procedures may produce different results. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application. The selection and use of specific products is solely within the control of, and remains the sole responsibility of the customer. The right to change design and/or specifications without notice is reserved.