… feather. The deposit is not mashinable or forgeable. Only grinding with diamond tools is possible.Dur R (Ni) is available as a 500 mm … cast iron or Mn-steel. The main applications are hardfacing and rebuilding of stabilisers and other oilfield tools where maximum protection …

… no limit for the number of layers that can be applied in case of rebuilding but heat input should be kept low (as for Mn steel, interpass temperature should be kept < 250 °C). … Rebuilding and joining cold straining Mn steels or rebuilding parts that are subject to high impact and rolling wear. Breaker …

… 400”. It has good strength and resists corrosion in many media, including sea water, salts and reducing acids. The weld metal is not age … NiCu30Fe, NiCu30Al, Monel 400, R405, Alloy K500 and dissimilar welding between these Alloys. … E NiCu30Mn … A 5.11: E NiCu-7 … 14172: E …

… hardness in the first layer. The choice for the buffer layer is depending on the base metal and not always necessary.  … 55-57 HRc …

… Excellent gliding properties against metal to metal wear due to its low friction, … and can resist severe shock and impact at these temperatures. … Cladding seats and valves in extreme high temperaure engines, hot sharing …

… of intergranular corrosion. The higher silicon content improves the welding properties such as wetting and results in a bright seam. … ISO 15608: 8.1  Austenit ≤ 19 % Cr , TÜV 1000: Gr. 21-30,  1.4583, …

… deposits are air-hardenable that can normally be heat-treated after welding. … 1.4000, 1.4001, 1.4002, 1.4003, 1.4006, 1.4008,  1.4021, …

… base material or old layers. Weldable without protective gas.Corresponding electrode: CEWELD® Dur 62 S … 61-64 HRc hardfacing alloy, Cement, …

… yield and impact strength due to high manganese content, excellent welding properties in combination with FL 851 and FL 155 … S550GD, S355JO, …

… alternative for „stelliting“ . Best to be used with FL 8111 welding flux.  … Hot working tools such as: Stamping dies and Continuous …