… The deposit is not mashinable or forgeable. Only grinding with diamond tools is possible.Dur R (Ni) is available as a 500 mm flexible rod or … are hardfacing and rebuilding of stabilisers and other oilfield tools where maximum protection is required. Also for augers, impellers, …

… strength and good corrosion resistance, notably to oxidation, at service temperatures ranging from 1200°F (650°C) up to 1600°F (870°C) … …

… should be maximum 250ºC. The weld metal is machinable with carbide tip tools, hardening is possible. The maximum hardness is dependent on the …

… other forms of attack. The weld deposit is machinable with carbide tools. … Valves in chemical and steam plants, Gasturbine components, Tong bits, Share blades, Hot forging and stamping tools, Hot dies, Aerospace industry, Turbo charger buckets, Hot liquid …

… effectively. This results in improved product development and customer service. Additionally, carrying a single brand is cost-efficient, …

… be maximum 250ºC. The weld metal is machinable by special carbide tools, hardening is possible. The maximum hardness is dependent on the …

… The spray deposit is only machinable by grinding with diamond tools. … Cement industry, pumps, mixer blades, valves seals, bearings, …

… SP 1.4115. The spray deposit cannot be machined with normal cutting tools, grinding is possible. Hardness approximately 50 HRc … Flame …

… Filler metal specifically intended for high integrity structural service at elevated temperature so the minor alloy additions …

… consumables are specifically intended for high integrity structural service at elevated temperature so the minor alloy additions …