1. … feather. The deposit is not mashinable or forgeable. Only grinding with diamond tools is possible.Dur R (Ni) is available as a 500 mm … cast iron or Mn-steel. The main applications are hardfacing and rebuilding of stabilisers and other oilfield tools where maximum protection …
  2. … conductivity. Good corrosion resistance against seawater. Excellent sliding properties (bearings etc.) … Tin bronze alloy with high percentage of tin for virtually all welding procedures. Very good deoxidisation and high hardness similar to …
  3. … of the Plate Pro 6072 Wear system: 10 times faster than overlay welding by SMAW. No dilution with the basemetal and a full high hardness …
  4. … Solid drawn ,corrosion-resistant, chromium-nickel wire for welding heat-resistant austenitic steels of the 25% Cr, 20% Ni types. … relatively severe thermic shock, and is superior to type 309 L. … ISO 15608: 8.1  Austenit ≤ 19 % Cr , TÜV 1000: Gr. 21-30,  Type: 25% …
  5. … Excellent welding properties with high build-up capacity and low dilution rate. … medias. Excellent fatigue strength and creep properties. … Cladding against high temperature, radiant heater tubes, furnace rolls, …
  6. … alloy excellently suitable for metal to metal wear. Machinable by grinding. … Turbine guide vanes, wire-drawing dies, fan blades, pump …
  7. … For welding heat-resistant austenitic steels of the 25% Cr, 20% Ni types. …
  8. … from sand and minerals. The weld metal is machinable only by grinding. Stringer bead technique is recommended. The hard surfacing …
  9. … For welding heat-resistant austenitic steels of the 25% Cr, 20% Ni types. AA … relatively severe thermic shock, and is superior to type 309L … ISO 15608: 8.1  Austenit ≤ 19 % Cr , TÜV 1000: Gr. 21-30,  Type: 25% …
  10. … the field short arc and spray arc. Excellent gap bridging for root welding. High-efficiency type for economic production enviroments … even after long storage in unconditioned condition. … Typ 1Cr0,5Mo, ISO 15608: ~5,1 1.7335, 1.7262, 1.7728, 1.7218, …